Sennheiser NET 1 Spécifications télécharger pdf (Page 13)

Connecting the NET 1 to a PC

The following applications with up to five NET 1 require the connection of a

PC :

y Systems with up to 50 evolution wireless G2 receivers

y Systems with up to 25 EM 3532 twin receivers

y Mixed systems consisting of evolution wireless G2 receivers and EM 3532

twin receivers

The MAC addresses of the NET 1 are indicated on the type plate  (refer to

the instructions for use of the “Wireless Systems Manager” software).

왘 Connect one of the sockets LAN 1  or LAN 2  of the first NET 1 to the

PC using an Ethernet cable.

왘 Then connect additional NET 1 via the sockets LAN 1  and LAN 2 

using Ethernet cables. The sockets LAN 1 and LAN 2 are identical, so it

doesn't matter in which order you connect them.

Note:

It is also possible to connect up to five NET 1 to a PC using a switch or a

router with switching function.

Installing the “Wireless Systems Manager” software

In order to operate the NET 1 with a PC, you have to install the “Wireless

Systems Manager” software (refer to the software installation manual).

Switching on a NET 1 system

For reliable detection of the receivers, we recommend the following sequence:

1. Switch on all receivers.

2. Switch on the NET 1.

Note:

All devices can simultaneously be switched on via a main switch.

3. Switch on the PC and start the “Wireless Systems Manager” software.

4. If necessary, update the firmware of all transmitters and receivers you

want to configure.



 

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

Sennheiser NET 1 Spécifications Page 13