Sennheiser NET 1 Spécifications télécharger pdf (Page 14)

Switching on the receivers

왘 Switch on the receivers as described in the instructions for use of the

receivers.

Switching on the NET 1

왘 Press the ON/OFF switch  to switch on the NET 1.

After switch-on, the green “READY” LED  flashes, indicating that the

NET 1 is being initialized. As soon as the NET 1 is ready for operation, the

“READY” LED  lights up permanently and the infra-red interface  is

permanently backlit in blue.

If a receiver is connected correctly and is detected by the NET 1, the

corresponding green “CHANNEL” LED  lights up permanently.

Switching on the PC and starting the “Wireless Systems Manager” software

왘 Switch on the PC as described in the instructions for use of the PC.

왘 Start the “Wireless Systems Manager” software as described in the

instructions for use of the software.

If communication between the PC and the NET 1 works properly, the yellow

“REMOTE” LED  on the NET 1 (and on all daisy-chained NET 1) lights up

permanently.





 



1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Pas de commentaire

Sennheiser NET 1 Spécifications Page 14