Sennheiser evolution wireless series EM 100 Manuel d'utilisateur télécharger pdf (Page 43)

Synchronizing transmitters with receivers

Synchronizing transmitters with

receivers

When synchronizing a transmitter with a receiver, please observe the

following:

Synchronizing a transmitter with the receiver –

individual operation

Upon delivery, transmitter and receiver are synchronized with each other.

If, however, you cannot establish a transmission link between transmitter

and receiver, you have to synchronize the channels of the devices.

왘 With the receiver, perform a frequency preset scan to scan the

frequency banks for unused channels (“Scan New List”, see page 34).

Then “Sync” appears on the display panel of the receiver.

왘 Synchronize a transmitter with the receiver via the infra-red interface

(see page 20).

This establishes a transmission link between the transmitter and the

receiver.

Alternatively, you can set the channel on the transmitter manually:

왘 Make sure that you set the transmitter to the same frequency bank and

the same channel as the receiver (see the instruction manual of the

transmitter).

왘 Only use a transmitter and a receiver from the same frequency

range (see the type plate on the transmitter and the receiver).

왘 Make sure that the desired frequencies are listed in the enclosed

frequency information sheet.

왘 Make sure that the desired frequencies are approved and legal

in your country and, if necessary, apply for an operating license.

533.875 MHz

Easy Setup

B.Ch: 20.12

PEAK

-10

-20

-30

Sync

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 58 59

Pas de commentaire

Sennheiser evolution wireless series EM 100 Manuel d'utilisateur Page 43